Shenzhen Dataifeng Technology Co., Ltd. is a collection of design, production, maintenance and sales... View more
Model: DT-F120S Design Date: The first product molded in 2013 DT-F100 was tested by the company in 2014, and the design was changed. The air diffuser holes on the panel were changed to the heat sink holes that can be used for cooling fans. Modification: DT-F120 In October 2014, employees reported that the cabinet ’s temperature will exceed the standard for long-term use, and it is improved to a double-layer thermal insulation design, and the plane type machine is convenient for chip extraction. Main parameters: Total work rate Max120
DT-F610 BGA rework station Features and parameters of DT-F610 rework station: 1. Independent three-temperature zone temperature control system 1. The upper and lower temperature zones are heated by hot air, the IR preheating zone is infrared heating, and the temperature is precisely controlled at ± 3 ° C.
· o o o RKC温控器 - REX-C100 o RKC温控器系列 - 精品推荐 o RKC温控器 - CB-900RKC温控器 - CD-701RKC温控器 - CH-102REX-C400 o RKC温控器 - REX-C100 - 详细信息 o RKC温控器使用警告·
RK26XX chip application introduction of common fault analysis/maintenance & NBSP;1. Power supply to the machine with power supply. After pressing the boot button, the current will start up.This fault is generally caused by the fact that the current amplification factor of the transistor of the switch on/off circuit is too small or the transistor is damaged. When the switch on button is pressed, PLAY_ON should be close to the battery voltage and PWR_ON should be at a high level (3.3V). If the voltage of the two points is abnormal, the transistor is usually damaged, and the field effect tube (IS23) is the fault