Design Date: 2013 first product molding DT-F100
It was tested and used by the company in 2014, and the design was changed. The air diffuser holes on the panel were replaced with heat sink holes that can be used for cooling fans. Modification: DT-F120
In October 2014, employees reported that the cabinet's long-term use would cause the temperature to exceed the standard, which was improved to a double-layer thermal insulation design, and a flat-type machine to facilitate chip extraction.
AC 220V±10％ 50/60Hz
Cold and hot isolation design, plane extraction positioning
K-type thermocouple (K Sensor) closed-loop control, accuracy can reach ± 3 degrees
dimenssion of platform
Design of input and output circuit of highly sensitive temperature control module
DT-F120S main features:
1. Can be set to remind the heating time timing.
2. With hot and cold heating plate, independent heating compartment design, to ensure the temperature isolation ability of the two plates.
3. Real-time temperature display.
4. The function configuration is upgraded to increase the installation position of the exhaust fan.
5. Using three imported high-power heating tubes, the constant temperature heating temperature is more stable and accurate.
6. Humanized design, comprehensive consideration of operator's safety protection.