There are three basic forms of X-RAY detection equipment: manual, semi-automatic and fully automatic. In general, X-RAY inspection equipment can be used at each different stage of the manufacturing process. Including: component input, process monitoring, quality control and fault analysis. The operator estimates and analyzes the X-RAY images to determine which defects to show. The tests provided by the device are very flexible and can speed up operation time. No expensive training or equipment programming is required.
The semi-automatic X-RAY inspection equipment is equipped with a mechanical observation and device position programmable console, and the integrated analysis of the device patches and welds is based on preset grayscale parameters. The setup of the program can generally be based on an already determined quality to determine the PCB assembly board for initial setup or using CAD(computer aided design) placement information and Navigation program. Compared with semi-automatic operating equipment, semi-automatic X-ray inspection equipment has a fairly reliable productivity.
Automatic X-RAY detection equipment is generally used in high yield, low complexity, characterized by the use of transmission tape technology, linear rate design. All detection work is automated and its operation is mainly based on image analysis.
The above is about the X-RAY inspection equipment in three forms, I hope to help you ~
BE MY FRIEND:
Check out my email address: firstname.lastname@example.org
warning! are you avoiding Professional BGA Repair Station Manufacturer mistakes?
#dataifeng #BGA rework station #manufacturer #factory #factorywork